To download article.УДК 621.182.3
DOI: 10.15507/0236-2910.027.201704.577-591
Evaluation of Efficiency of Boiler Units in Their Group Specific Fuel Consumption
Aleksey P. Levtsev
Head of Heat and Power Systems Chair, Institute of Mechanics and Power Engineering, National Research Mordovia State University (68 Bolshevitskaya St., Saransk 640005, Russia), Dr.Sci. (Engineering), Professor, This email address is being protected from spambots. You need JavaScript enabled to view it.
Olga A. Kruchinkina
Master’s Degree Student, Institute of Mechanics and Power Engineering, National Research Mordovia State University (68 Bolshevitskaya St., Saransk 640005, Russia), This email address is being protected from spambots. You need JavaScript enabled to view it.
Shi Yuan Yuan
Master’s Degree Student, Institute of Mechanics and Power Engineering, National Research Mordovia State University (68 Bolshevitskaya St., Saransk 640005, Russia), Jiangsu University (Road Zhenjiang, Jiangsu, China), This email address is being protected from spambots. You need JavaScript enabled to view it.
Introduction: Specific fuel consumption (SFC) for the boiler is the most important performance indicators of the work, both in the current and projected periods. The technical installation of metering stations of thermal energy from the boiler made it possible to evaluate the actual SFC over the period of interest with sufficient accuracy. However, the problem of controlling modes for operation of boiler units, which allows obtaining the minimum SFS remained unresolved. This paper presents the algorithm of finding the optimal group SFC for the boiler depending on the outside temperature. This approach is based on the linear programming method.
Materials and Methods: The study of the group specific fuel consumption was carried out using the results of technological audit in Ruzaevka (Republic of Mordovia) in 2016–2017. For analysis we selected two district boiler with loads more 10 Gcal/hour. We used the general scientific methods and methods of linear programming.
Results: To reveal the dependence of the effect of the order of operation of boiler units in their group SFC we developed an algorithm and a program. This problem can be solved by linear programming methods. The algorithm for finding the optimal group SFC represents a sequence of steps. The algorithm is implemented using a spreadsheet program in two boilers in Ruzaevka. We presented the calculated minimum, maximum and average SFC for the production of thermal energy from each of the boiler depending on the outdoor temperature.
Discussion and Conclusions: One of the most effective and low-cost measures to reduce SFC for the heat energy from the boiler is to increase the accuracy of the compliance regimes of burning and strict compliance with the order of the boilers. The problem of determining the optimal order of operation of boiler units with a variety of individual SFC for the production of thermal energy from boilers is solved by linear programming. The findings of this study have a number of practical implications in the heating systems.
Keywords: specific fuel consumption, boiler, method of linear programming, regime map, heat energy, heat distribution company, load
For citation: Levtsev А. Р., Kruchinkina O. A., Yuan Yuan Shi. Evaluation of Efficiency of Boiler Units in Their Group Specific Fuel Consumption. Vestnik Mordovskogo universiteta = Mordovia University Bulletin. 2017; 27(4):577–591. DOI: 10.15507/0236- 2910.027.201704.577-591
This work is licensed under a Creative Commons Attribution 4.0 License.
