Engineering Technologies and Systems - 23. Sсhekin A. V., Sul’din S. P., Mitin E. V. [Post-processor of NC system «MAJaK 600T» for CAMapplication

UDK 621.941

POST-PROCESSOR OF NC SYSTEM «MAYAK 600T» FOR CAM-APPLICATION

Shhjokin Aleksandr Vasil’evich (engineer of Machine Tools and Systems chair of Machine Building Institute (Ruzayevka campus) of Ogarev Mordovia State University (Ruzaevka, Russia), Kandidat Nauk degree holder in Engineering sciences, docent, This email address is being protected from spambots. You need JavaScript enabled to view it.)

Sul’din Sergej Petrovich (associate professor (docent) of Machine Tools and Systems chair of Machine Building Institute (Ruzayevka campus) of Ogarev Mordovia State University (Ruzaevka, Russia), Kandidat Nauk degree holder in Engineering sciences, docent, This email address is being protected from spambots. You need JavaScript enabled to view it.)

Mitin Jeduard Valer’evich (engineer of Engineering Technology chair of Machine Building Institute (Ruzayevka campus) of Ogarev Mordovia State University (Ruzaevka, Russia), Kandidat Nauk degree holder in Engineering sciences, docent, This email address is being protected from spambots. You need JavaScript enabled to view it.)

This article describes a method for post-processing, which provides an efficient opportunity of including machine cycles in NC-programs. We have considered the possibility of the automated breakdown of machining allowance to geometrical figures of machine cycles.

Keywords: CAM, KOMPAS-3D, NC-program, post-processor, machine cycle, cutting tool, 3D-model, Python, visualization.

For citation: Sсhekin A. V., Sul’din S. P., Mitin E. V. Postprocessor sistemy ChPU «MAJaK 600T» dlja CAMprilozhenija «Modul’ ChPU. Tokarnaja obrabotka» [Post-processor of NC system «MAJaK 600T» for CAMapplication]. Vestnik Mordovskogo Universiteta – Mordovia University Bulletin. 2014, no. 1, pp. 161 – 164.

This work is licensed under a Creative Commons Attribution 4.0 License.