To download article.UDK 378.147:681.5
DOI: 10.15507/VMU.025.201501.052
USE OF SOFTWARE SYSTEMS IN THE STUDY OF STUDENTS OF SPECIAL SUBJECTS
Fedchenko Aleksandr Andreyevich
(senior lecturer of General Educational and Professional Disciplines chair of Ruzaevka Machine Engineering Institute, branch of Ogarev Mordovia State University (93, Lenin Str., Ruzaevka, Russia), Candidate of Sciences (PhD) degree holder in Physico-Mathematical sciences, This email address is being protected from spambots. You need JavaScript enabled to view it.)
Fedchenko Valentina Yuryevna
(associate professor (docent) of Machine Tools and Systems chair of Ruzaevka Machine Engineering Institute, branch of Ogarev Mordovia State University (93, Lenin Str., Ruzaevka, Russia), Candidate of Sciences (PhD) degree holder in Engineering sciences, This email address is being protected from spambots. You need JavaScript enabled to view it.)
Maskaykina Svetlana Egorovna
(associate professor (docent) of Machine Tools and Systems chair of Ruzaevka Machine Engineering Institute, branch of Ogarev Mordovia State University (93, Lenin Str., Ruzaevka, Russia), This email address is being protected from spambots. You need JavaScript enabled to view it.)
Buryanov Igor Valeryevich
(5th year student of specialty ‘‘Machine Tools and Systems’’ of Ruzaevka Machine Engineering Institute, branch of Ogarev Mordovia State University (93, Lenin Str., Ruzaevka, Russia), This email address is being protected from spambots. You need JavaScript enabled to view it.)
The article considers the opportunity of implementation of MathCAD software package in course of computer science for students of engineering disciplines for solution to specific problems in their area of expertise. Calculation of the center of mass of the machine tool by using matrices is shown on an example. Each node of the machine approximated by simple geometrical figures, the accuracy of the calculation is dependent upon the level of detail of the machine. Recommended procedure makes possible to create a template for the calculation of the center of mass of machines with a similar layout. For the development of engineering skills it is useful to study the variation of the position of the center of mass, depending on the layout of the machine and node filling factor.
Keywords: software package, machine tool, center of mass, unit of machine tool, coordinate, approximation, matrix, vector.
For citation: Fedchenko A. A., Fedchenko V. Yu., Maskaykina S. E., Buryanov I. V. Ispolzovanie pro- grammnykh kompleksov pri izuchenii studentami spetsialnykh distsiplin [Use of software systems in the study of students of special subjects]. Vestnik Mordovskogo Universiteta – Mordovia University Bulletin. 2015, vol. 25, no. 1, pp. 52–58. DOI: 10.15507/VMU.025.201501.052
This work is licensed under a Creative Commons Attribution 4.0 License.