Engineering Technologies and Systems - 06. Mironov YeV, Lisunov YeA, Krupin AYe, Tarukin YeM. A device for making protective compounds at the agricultural equipment conservation

UDC 637.023

DOI: 10.15507/0236-2910.026.201604.490-498

A DEVICE FOR MAKING PROTECTIVE COMPOUNDS AT THE AGRICULTURAL EQUIPMENT CONSERVATION

Yevgeniy B. Mironov
associate professor of Technical Service Chair, Nizhny Novgorod State Uni¬versity of Engineering and Economics (22, Oktyabrskaya St., Knyaginino, Russia), Ph.D. (Engineering), ORCID: http://orcid.org/0000-0002-7842-0377, This email address is being protected from spambots. You need JavaScript enabled to view it.

Yevgeniy A. Lisunov
professor of Technical Service Chair, Nizhny Novgorod State University of Engineering and Economics (22, Oktyabrskaya St., Knyaginino, Russia), Dr.Sci. (Engineering), ORCID: http://orcid.org/0000-0001-9002-2665, This email address is being protected from spambots. You need JavaScript enabled to view it.

Aleksandr Ye. Krupin
senior lecturer of Technical Service Chair, Nizhny Novgorod State University of Engineering and Economics (22, Oktyabrskaya St., Knyaginino, Russia), Ph.D. (Engineering), ORCID: http://orcid.org/0000-0002-7497-353X, This email address is being protected from spambots. You need JavaScript enabled to view it.

Yevgeniy M. Tarukin
senior lecturer of Technical Service Chair, Nizhny Novgorod State University of Engineering and Economics (22, Oktyabrskaya St., Knyaginino, Russia), ORCID: http://orcid.org/0000-0001-9075-3767, This email address is being protected from spambots. You need JavaScript enabled to view it.

Introduction: The article deals with the protective anti-corrosive compounds for agricultural machinery. Agriculture has a significant fleet of machines, tools and mechanisms. Advanced methods and tools are needed for preservation of surfaces from corrosion. Many of research teams solve this relevant problem and offer devices for the preparation and application of various protective anti-corrosive compounds and greases for surfaces of agricultural machinery.
Materials and Methods: The paper presents the design and operation of installation for the preparation and application of protective grease. A heat source and the indirect heating the material by a heat carrier are distinctive features of the device.
Results: The theoretical dependence of induction heater power on temperature, quantity and time of heating the protective grease was obtained.
Discussion and Conclusions: Agricultural enterprises haven’t possibility to conserve technical equipment in time due to a variety of reasons. The combination of many factors leads to the necessity of creating device with minimal energy for producing protective compositions and maintaining work temperature requirements throughout the entire time.

Keywords: conservation, indirect heating, construction parameters, agricultural machinery, device for preparation and application of protective coatings, storage

For citation: Mironov YeV, Lisunov YeA, Krupin AYe, Tarukin YeM. A device for making protective compounds at the agricultural equipment conservation. Vestnik Mordovskogo universiteta = Mordovia University Bulletin. 2016; 4(26):490-498. DOI: 10.15507/0236-2910.026.201604.490-498

This work is licensed under a Creative Commons Attribution 4.0 License.